Offset smoker in Denmark :)

Horizontal smokers with a side firebox and tuning plates.
Post Reply
Freiesleben
beginner
beginner
Posts: 12
Joined: February 21st, 2016, 1:09 pm

Offset smoker in Denmark :)

Post by Freiesleben » August 8th, 2019, 2:49 pm

Finally I am starting the preparations for my offset smoker 🙂 I had some brackets at work we had used for some special equipment and these were being thrown in the trash.

So I took these and made hinges of them instead, just think that I have to replace the bolt hole a bit, to lift the part of the hinge that is attached to the door.

https://photos.app.goo.gl/kU5cxyEexiAfoDXF8



User avatar
Big T
Moderator
Moderator
Posts: 5640
Joined: September 1st, 2013, 2:40 pm
Title: Go Getter
BBQ Comp Team Name: Backyard Boys
Location: Lower Alabama

Re: Offset smoker in Denmark :)

Post by Big T » August 8th, 2019, 7:13 pm

:kewl:


Measure Twice.....Cut Three Times.

User avatar
McBroom
Expert
Expert
Posts: 316
Joined: January 31st, 2018, 10:02 am
Title: Retired U.S.Marine
BBQ Comp Team Name: Not competing yet...
Location: Denison Texas

Re: Offset smoker in Denmark [emoji3]

Post by McBroom » August 8th, 2019, 7:18 pm

Those hinges a really nice. I like the shape


- The Blue Mule



User avatar
ajfoxy
Expert
Expert
Posts: 2244
Joined: April 12th, 2016, 8:07 pm
Title: Neophyte Smoker Bldr
BBQ Comp Team Name: Not competing yet...
Location: Brisbane, Queensland, Australia

Re: Offset smoker in Denmark :)

Post by ajfoxy » August 8th, 2019, 9:42 pm

Very nice. I like recycling steel where I can.


Learning generally boils down to "Repetition or the avoidance of pain", some people learn by doing, some by watching and some just have to pee on the electric fence.

Whether you think that you can, or that you can't, you are usually right. Henry Ford

Freiesleben
beginner
beginner
Posts: 12
Joined: February 21st, 2016, 1:09 pm

Re: Offset smoker in Denmark :)

Post by Freiesleben » August 11th, 2019, 1:53 am

Thanks for the comments guys, I will make sure to post more once I get further with the build. I still need to do a bit of sanding on the hinges, after I cut them with the angle grinder.



Post Reply

Return to “Standard Offsets”