I started with the mini plans but tweaked it quite a bit. The cook chamber is a little bigger in all dimensions since I wanted 2 racks that would hold 2 briskets per rack. I flipped the drip pan and transfer tube too similar to an Assassin. It's more of an Assassin clone than anything else. I'll have the air inlet come out the side next to the ash door too.
I also decided to try the entire burn assembly out of 0.25 steel. I'll assemble it and run some charcoal through it and see what happens. If it fails we can all have a good laugh.

I had no idea the mesh I was getting was so thick. Might find something thinner.
Here's my CNCd parts.
